Pool Resurfacing Guide

Pool Surface Area Calculator

STEP 1	-	SURFACE CLEANING: Clean surface with a tri-sodium phosphate solution.
STEP 2	-	SURFACE PREPARATION: Apply a muriatic acid solution to pool surfaces to etch or remove mineral deposits. Neutralize surface before coating with Pool Bright.
STEP 3	-	RESURFACING: Pool Bright will protect and beautify your pool for years of enjoyment. Upon completion of step 3, follow drying instructions on label prior to filling.

SURFACE CLEANING

If your pool is chipping or peeling, scrub with a wire brush. If your pool is chalking or fading, use a stiff nylon brush to remove all loose chalk. All surfaces need to be cleaned with a tri-sodium phosphate type solution to remove dirt, grease and oil.

SURFACE PREPARATION

All surfaces then need to be acid etched with 15% to 20% solution of muriatic acid or sulfuric acid. On a previously painted surface, this process will remove any mineral deposits. On new or bare concrete surfaces, this process should achieve a medium sandpaper type texture. Neutralize your surface with TSP and rinse. No residual acid should be left on your pool. Note: follow manufacturer's safety precautions prior to using any acid products. Never pour water into acid. Always pour acid into water.

RESURFACING YOUR POOL WITH Pool Bright

Follow the specific directions on the back label for the type of Pool Bright you are purchasing. This information is also available on the Pool Bright Application Sheets.